TM 5-3800-205-10-1
RAIL TRANSPORT - CONTINUED
0021 00
CONFIGURE MACHINE FOR RAIL TRANSPORT - CONTINUED
3.
If machine is being transported by rail (CONUS), machine needs no further preparation. Proceed to Load Machine Onto
Flatcar on page 0021 00-21.
4.
OCONUS ONLY: Place transmission in N (Neutral) and lock, apply parking brake, lower bowl to the ground and shut
down engine. Block tractor and scraper wheels.
5.
OCONUS ONLY: Remove two nuts and windshield wiper arm assembly from windshield. Set wiper arm assembly
aside for stowage in ISU-60 container. Reinstall nuts on drive and pivot shafts.
PIVOT AND
WINDSHIELD WIPER
DRIVE SHAFT NUTS
ARM ASSEMBLY
390-1060
WINDSHIELD
6.
OCONUS ONLY: Cut tiedown strap and disconnect two electrical connectors at wiper motor inside cab. Discard
tiedown strap.
ELECTRICAL
ELECTRICAL
TIEDOWN STRAP
CONNECTION CONNECTION
390-1053
0021 00-5
