TM 5-3800-205-10-1
RAIL TRANSPORT - CONTINUED
0021 00
UNLOAD MACHINE FROM FLATCAR - CONTINUED
WINDSHIELD WIPER
ARM ASSEMBLY
UPPER
STACK
HANDRAIL
(WITH SIDE
MIRROR)
RAMPS
TRAY
RETAINING
PIN
TOOLBOX ROPS/FOPS
WINDSHIELD
(WITH HINGE)
390-1124
Table 4. Unpacking ISU-60 Container - Single-Door End.
COMPONENT
UNPACKING INSTRUCTIONS
Ramps
1.
Remove two roller ramps from right-side wall of container.
2.
Install each ramp at door opening, with two pins through each ramp into holes in edge of
floor.
Toolbox
1.
Remove two pins and slide out tray.
2.
Release three straps and remove toolbox from tray.
ROPS/FOPS
1.
Release two straps from ROPS/FOPS.
WARNING
ROPS/FOPS weighs 447 lb (203 kg). Use extreme caution when lifting and do not
allow to swing free. Failure to do so may result in injury or death to personnel.
CAUTION
Use caution not to damage windshield when handling ROPS/FOPS.
2.
Use a suitable three-point lifting device to lift ROPS/FOPS clear of tray.
CAUTION
Windshield (with
Hinge)
Use caution not to damage windshield during handling. Do not remove from container
until ready to install.
1.
Release one strap from windshield.
2.
Carefully remove windshield (with hinge) from cushion pad.
NOTE
To remove all remaining components, remove straps as required and lift out compo-
nent.
0021 00-29
