TM 5-3800-205-23-1
FRONT WHEEL, HUB, BRAKE DISC, AND WHEEL BEARINGS AND SEALS
MAINTENANCE - CONTINUED
0080 00
INSTALLATION AND WHEEL BEARING ADJUSTMENT - CONTINUED
g.
Calculate difference between measurements in step a and step f. Difference is gap between end of spindle and
retainer plate (6).
h.
Remove three bolts (5) and retainer plate (6)
4
2
5
from spindle.
i.
Assemble quantity of shims, so that shim pack
thickness is equal to measurement in step g plus
0.203 mm (0.008 in.).
j.
Install shims, retainer plate (6) and eight bolts
(5). Tighten bolts to 44 lb-ft (60 Nm), then
tighten an additional 120.
6
WARNING
Use extreme caution when handling heavy parts. Provide adequate support and use assistance during proce-
dure. Failure to follow this warning may result in injury to personnel.
NOTE
Ring gear weighs 45 lb (20 kg).
4.
With assistance, install ring gear (1) to hub (2) with
1
2
retaining ring (3).
390-896
3
5.
Install brake caliper (WP 0087 00).
6.
Install final drive (WP 0077 00).
END OF WORK PACKAGE
0080 00-7
