TM 5-3800-205-23-1
FRONT SERVICE BRAKESHOES REPLACEMENT - CONTINUED
0084 00
REMOVAL - CONTINUED
2.
Loosen bolts (4) and install 1/2 in. - 13NC bolts (n
2
1
3
pins (3).
3.
Tighten bolts to remove pins (3) and brakeshoes (6)
from brake caliper (2).
6
4
3
5
CLEANING AND INSPECTION
1.
Clean and inspect all parts.
2.
Measure thickness of brakeshoes at each end. Minimum allowable thickness in area of most wear of a used brakeshoe is
0.591 in. (15.01 mm).
3.
Replace worn and damaged parts.
INSTALLATION
1.
Remove 1/2 in. - 13NC bolts from pins (3).
2.
Install brakeshoes (6) in brake caliper (2) with pins (3). Tighten four bolts (4).
3.
Check clearance between pin (3) and brake disc (5):
a.
Clearance between pin (3) and brake disc (5) must not be less than 0.010 in. (0.25 mm) and not more than 0.118 in.
(3.00 mm).
b.
If clearance between pin (3) and brake disc (5) is less than 0.010 in. (0.25 mm), loosen bolt (4) and slide pin (3) to
obtain required clearance.
4.
Tighten two bleeder screws (1).
5.
Bleed air from brake system (WP 0095 00).
6.
Install tire and rim (WP 0096 00).
END OF WORK PACKAGE
0084 00-2
