TM 5-3800-205-23-1
PARKING BRAKE OR EMERGENCY BRAKE CONTROL VALVE REPLACEMENT - CONTINUED
0089 00
INSTALLATION
1.
Apply antiseizing tape to male threads of adapters, tees, and elbows.
2.
Install adapters, tees and elbows in new valve (5).
3.
Connect two hoses (13) to valve (5).
4.
Apply antiseizing tape to male threads of switch (12).
5.
Install switch (12) in valve (5).
6.
Connect pressure switch connector (10) to harness connector (11).
7.
Position panel (9) on console, with valves (5) through panel openings. Secure panel with four screws (7) and washers
(8).
8.
Secure valves (5) in panel (9) with nuts (6).
9.
Position handles (3 and 4) on valves (5). Position lock handle (2).
10.
Install new spring pins (1) in handles (2, 3, and 4).
WARNING
If machine is parked indoors, DO NOT run engine unless exhaust fumes are vented to the outside. Failure to
follow this warning may cause injury or death due to carbon monoxide poisoning.
11.
Start engine and fully charge air system (TM 5-3800-205-10-1 or TM 5-3800-205-10-2).
12.
Operate parking or emergency brake control (TM 5-3800-205-10-1 or TM 5-3800-205-10-2). With assistance, check for
air leaks.
END OF WORK PACKAGE
0089 00-3