TM 5-3800-205-23-1
PARKING BRAKE ACTUATOR REPLACEMENT - CONTINUED
0088 00
INSTALLATION
1.
If removed, install bracket (12) to transfer case (9) with two washers (11) and bolts (10).
2.
Position parking brake actuator (1) on bracket (12).
3.
Align yoke rod end (6) with parking brake lever and install two washers (8) and nuts (7). Tighten nuts to 89 lb-ft (120
Nm).
NOTE
Apply antiseizing tape to male threads of fittings before connection is made.
4.
Position hose (2) on parking brake actuator (1) and tighten nut (3).
5.
Install clevis pin (5) and new cotter pin (4) on yoke rod end (6).
6.
Place battery disconnect switch in ON position (TM 5-3800-205-10-1 or TM 5-3800-205-10-2).
WARNING
If machine is parked indoors, DO NOT run engine unless exhaust fumes are vented to the outside. Failure to
follow this warning may cause injury or death due to carbon monoxide poisoning.
7.
Start engine and fully charge air system (TM 5-3800-205-10-1 or TM 5-3800-205-10-2).
8.
Operate parking brake and check for air leaks.
END OF WORK PACKAGE
0088 00-3