TM 5-3800-205-23-1
ROCKER SHAFT GROUP REPLACEMENT - CONTINUED
0133 00
VALVE LASH ADJUSTMENT - CONTINUED
NOTE
Do NOT allow adjustment screw to turn while tightening.
4.
Tighten adjustment nut (3) to 18 lb-ft (25 Nm).
Recheck valve lash after tightening adjustment nut.
3
5.
Turn flywheel 360 in direction of engine rotation. This will put no. 6 piston at top center position on compression
stroke.
6.
Repeat steps 3 through 5 for remaining valves.
7.
Verify injector timing (WP 0140 00).
8.
Install rocker arm cover (WP 0011 00).
END OF WORK PACKAGE
0133 00-4
