TM 5-3800-205-23-1
DIFFERENTIAL AND BEVEL GEAR REPLACEMENT - CONTINUED
0152 00
REMOVAL - CONTINUED
10.
Position floor jack under differential and remove ten
1
13,14
bolts (13) and washers (14). Leave two bolts installed
at top of differential to hold differential in axle hous-
ing (1).
WARNING
Use extreme caution when handling heavy parts. Provide adequate support and use assistance during proc-
dure. Ensure that any lifting device used is in good condition and of suitable lift capacity. Keep clear of
heavy suitable lift capacity. Keep clear of heavy parts supported only by lifting device. Failure to follow this
warning may result in death or injury to personnel.
NOTE
Differential weighs 450 lb (204 kg).
11.
Install two 3/8" - 16 NC forcing screws (15) on differ-
16,17
15
ential and remove two remaining in top bolts (16) and
washers (17) from differential. Use forcing screws to
remove differential from axle housing (1). Remove
forcing screws.
12.
Remove and discard O-ring (18).
18
1
0152 00-4
