TM 5-3800-205-23-1
DRAFT FRAME, HITCH, AND TRACTOR FRAME PINS AND
BEARINGS REPLACEMENT - CONTINUED
0155 00
DRAFT FRAME BEARINGS REPLACEMENT
1.
At lower end of draft frame (3), remove grease fitting (38).
2.
Using bearing puller and spacer sleeve, pull upper bearing (37) from draft frame (3).
3.
Adjust travel of bearing puller and pull lower bearing (39) from draft frame (3).
3
34
35
36
37
38
39
NOTE
Each of two bearings should be centered in draft frame and aligned with grease fitting hole in draft
frame.
Apply GAA grease to bearings before they are installed.
4.
Adjust travel of bearing puller and pull lower bearing (39) into draft frame (3).
5.
Adjust travel of bearing puller and pull upper bearing (37) into draft frame (3).
6.
Install grease fitting (38) to draft frame (3).
7.
At upper end of draft frame (3), remove two grease fittings (35).
8.
Repeat steps 2 through 5 to replace two bearings (34 and 36) at upper end of draft frame (3).
0155 00-9
