TM 5-3800-205-23-1
ELEVATOR/WATER PUMP CONTROL VALVE REPLACEMENT
THIS WORK PACKAGE COVERS
Removal, Installation
INITIAL SETUP
References
Maintenance Level
Direct Support
Tools and Special Tools
Personnel Required
Tool kit, general mechanic's (Item 33, WP 0172
Two
Equipment Condition
Sling, nylon (Item 27, WP 0172 00)
Machine parked on hard, level surface (TM 5-3800-
Materials/Parts
205-10-1 or TM 5-3800-205-10-2)
Scraper bowl or water tank lowered to ground (TM
Set, protective (Item 5, WP 0171 00)
5-3800-205-10-1 or TM 5-3800-205-10-2)
Oil, lubricating (Item 24 or 29, WP 0171 00)
Parking brake applied (TM 5-3800-205-10-1 or TM
Rag, wiping (Item 31, WP 0171 00)
5-3800-205-10-2)
Wheels chocked (TM 5-3800-205-10-1 or TM 5-
Tag, marker (Item 39, WP 0171 00)
3800-205-10-2)
O-ring (8)
Battery disconnect switch in OFF position (TM 5-
3800-205-10-1 or TM 5-3800-205-10-2)
Pin, cotter
WARNING
Do NOT disconnect or remove any hydraulic system line or fitting unless engine is shut down and
hydraulic system pressure has been relieved. Tighten all connections before applying pressure. Escap-
ing hydraulic fluid under pressure can penetrate the skin, causing serious injury.
At operating temperature hydraulic oil is hot. Allow hydraulic oil to cool before disconnecting any
hydraulics. Failure to do so could result in injury.
CAUTION
Cap all hoses and tubes to prevent fluid loss and contamination of the oil system.
NOTE
Ensure that fluids are contained during performance of inspection, maintenance, testing, adjusting and
repair of the machine. Be prepared to collect fluid with suitable containers before opening any compart-
ment or disassembling any component containing fluids.
Dispose of all fluids according to local regulations and mandates.
Tag all hoses and tubes to aid in installation.
