TM 5-3800-205-23-2
ELECTRICAL GENERAL MAINTENANCE INSTRUCTIONS - CONTINUED
0003 00
RECEPTACLE CONNECTOR REPAIR - CONTINUED
NOTE
Perform steps 4 through 7 only if receptacle was removed.
4.
Slide connector (15) back on wire (16).
15
16
17 18
19
20
390-1194
5.
Using wire stripping tool, strip insulation of wire (16) to expose 1/4 in. (6 mm) length of metal strands (17).
6.
Using crimping tool, securely crimp tabs (19) of receptacle (20) over metal strands (17).
7.
Using crimping tool, crimp tabs (18) of receptacle (20) over insulation of wire (16).
8.
Slide connector (15) forward over receptacle (20) until locking tab of receptacle snaps into place.
WATERPROOF CONNECTOR REPAIR
1.
Remove end cover (27) and gasket (26) from front of connector (25).
2.
Remove seal (21) from rear of connector (25) and slide seal back on wire (22).
25
21
24
23
26
22
27
390-1195
NOTE
Perform the following steps for each wire of connector.
Tag wires to aid in installation.
3.
Using pin removal tool, insert tool into front of connector (25) and depress locking tab of connector.
4.
Remove wire (22) with pin (24) from rear of connector (25).
5.
If defective, remove pin (24) from wire (22) by cutting through wire just behind pin.
0003 00-5
