TM 5-3800-205-23-2
REAR HUB AND DISC REPLACEMENT - CONTINUED
0009 00
REMOVAL - CONTINUED
NOTE
Hub weighs 250 lb (113 kg).
8.
Remove hub (3) from axle shaft (6).
9.
Remove 20 bolts (12), washers (13) and disc (14) from hub (3).
12,13
3
14
3
390-557
390-558
6
INSTALLATION
1.
Install disc (14) on hub (3) with 20 washers (13) and bolts (12). Tighten bolts to 148 lb-ft (200 Nm), then turn bolts
another 90.
WARNING
Use extreme caution when handling heavy parts. Provide adequate support and use assistance during proce-
dure. Ensure that any lifting device used is in good condition and of suitable lift capacity. Keep clear of
heavy parts supported only by lifting device. Failure to follow this warning may result in death or injury to
personnel.
NOTE
Hub weighs 250 lb (113 kg).
2.
Attach bearing link, two nylon slings, and a suitable lifting device to hub (3). Position hub on axle shaft (6).
0009 00-3
