TM 5-3805-248-10
TROUBLESHOOTING PROCEDURES - CONTINUED
0012 00
MALFUNCTION
TEST OR INSPECTION
CORRECTIVE ACTION
ENGINE - CONTINUED
2.
Engine Cranks but Fails to
Start (Operating
Temperature Below 32F
(0C).
WARNING
Do NOT perform fuel system checks, inspections or maintenance while smoking or near fire, flames or sparks. Fuel
may ignite, causing damage to machine and injury or death to personnel.
Operating personnel must wear fuel-resistant gloves and eye protection when handling fuels. If exposed to fuel,
promptly wash exposed skin and change fuel-soaked clothing.
1.
Check fuel level using fuel tank
If indication is empty, add fuel (WP 0014
dipstick.
00). If fuel level is okay, go to test step 2.
Open (push in) fuel shutoff valve as
2.
Check that fuel shutoff valve, located
required. If problem still exists, go to test
below left headlight, is fully open
step 3.
(pushed in).
NOTE
For every 30 seconds of engine cranking, allow 2 minutes for starter
motor to cool down.
If engine still will not start, notify Unit
3.
While cranking engine, press ether
Maintenance.
starting aid switch. Wait
approximately 2 seconds between
injections.
Check air filter service indicator.
If indicator is red, service air filter (WP
3.
Engine Does Not Develop
0015 00) and retest. If problem still exists,
Full Power.
notify Unit Maintenance.
Check air filter service indicator.
If indicator is red, service air filter (WP
4.
Engine Does Not Idle
0015 00) and retest. If problem still exists,
Properly.
notify Unit Maintenance.
