TM 5-3805-248-23-1
REAR HARNESS REPLACEMENT - CONTINUED
0120 00
REMOVAL - CONTINUED
6.
Remove 2 bolts (1), washers (2) and clamps (3).
7.
Remove bolt (17), washer (18) and separate clip (19) from wire connector (20).
8.
Disconnect wire connector (20).
1,2,3
17,18
19
20 (HIDDEN)
1,2
3
394-127
NOTE
Note location of all clamps and tie straps to ensure correct installation.
6
394-123
9.
Trace harness and remove all remaining tie straps and clamps from rubber shield (6).
10.
Fasten a piece of non-electrical wire (longer than rubber shield (6) and harness) to rear end of guard and harness before
removing from machine. This will make feeding harness through bowl easier.
11.
Remove rubber shield (6) and harness from machine by pulling through front of bowl. DO NOT pull non-electrical wire
completely out. Leave a tail at both ends.
12.
If necessary to replace rubber shield (6), remove harness from rubber shield.
0120 00-4