TM 5-3805-248-23-1
SCRAPER HARNESSES (INTERMEDIATE) REPLACEMENT - CONTINUED
0121 00
REMOVAL - CONTINUED
4.
Remove three clips (10) and disconnect three wire connectors (11).
5.
Trace harness and remove all remaining tie straps and clamps.
6.
Remove guard (4) and harness from machine.
7.
If necessary, remove all clamps (3 and 7) from guard (4) and remove harnesses from guard.
11
10
1,2,3
INSTALLATION
1.
If removed, install harnesses into guard (4).
2.
Position guard (4) and harness on machine.
3.
Trace harness and install all new tie straps.
4.
Connect three wire connectors (11) and install three clips (10).
5.
Connect three wire connectors (9) and install in clamp (8).
6.
Install all remaining clamps and tie straps on guard (4).
7.
If removed, install all clamps (3 and 7) on guard (4).
8.
Install two clamps (7), washers (6) and bolts (5).
9.
Install six clamps (3), washers (2) and bolts (1).
10.
Connect battery cables (WP 0104 00).
11.
Operate machine and verify correct operation (TM 5-3805-248-10).
END OF WORK PACKAGE
0121 00-3/(-4 blank)
