TM 5-3805-248-23-1
STEERING HOSES, LINES AND FITTINGS REPLACEMENT - CONTINUED
0180 00
INSTALLATION - CONTINUED
44.
If removed, install fittings on hydraulic steering servo-sender and receiver cylinders which connect to hose assemblies
(1, 2 and 3) (WP 0309 00 and WP 0311 00).
45.
Install hose assemblies (1, 2 and 3) on machine.
46.
Connect hose assembly (1) to multi-connector (WP 0233 00).
47.
Connect hose assemblies (2 and 3) to hydraulic steering servo-receiver cylinder (WP 0311 00).
48.
Connect hose assemblies (1, 2 and 3) to hydraulic steering servo-sender cylinder (WP 0309 00).
49.
Install all retaining hardware and straps on hose assemblies (1, 2 and 3).
1
3
2
394-459
50.
Refill hydraulic tank to proper level (TM 5-3805-248-10).
51.
Start engine (TM 5-3805-248-10).
52.
Operate steering. Move system through at least five full movements of travel. This will bleed the air out of the system.
53.
Shut down engine (TM 5-3805-248-10).
54.
Check oil level in hydraulic tank and add if necessary (TM 5-3805-248-10).
55.
Inspect all hose and tube assemblies for leaks.
56.
Install hood (WP 0189 00).
57.
Install crankcase guards (WP 0201 00).
END OF WORK PACKAGE
0180 00-12
