TM 5-3805-248-23-2
CYLINDER HEAD ASSEMBLY MAINTENANCE - CONTINUED
0259 00
INSTALLATION
1.
Using clean oil, lubricate cylinder liner walls.
NOTE
Do not use any gasket sealants or adhesives. Keep cylinder head mounting surfaces clean and dry.
2.
Install new gasket (13) to top of cylinder block.
3.
Install two new preformed packings (12) and block plate (11).
CAUTION
Petroleum products can damage spacer plate water seals resulting in premature failure.
4.
Install 24 new seals (10) in water ports.
5.
Install new gasket (20) to top of block plate (11).
10
WARNING
Use extreme caution when handling heavy
parts. Provide adequate support and use
assistance during procedure. Ensure that
20
any lifting device used is in good condi-
tion and of suitable load capacity. Keep
clear of heavy parts supported only by lift-
ing device. Failure to follow this warning
may result in death or injury to personnel.
11
NOTE
12
Weight of cylinder head assembly is 300 lb
(136 kg).
6.
Install lifting device to cylinder head assembly.
13
7.
Use lifting device to install cylinder head assembly on
cylinder block.
8.
Slowly lower cylinder head assembly, checking 24
new seals (10) for proper seating.
CYLINDER
LINER WALLS
CYLINDER
BLOCK
394-621
0259 00-11
