TM 5-3805-248-23-2
FLYWHEEL HOUSING REPLACEMENT - CONTINUED
0262 00
INSTALLATION
NOTE
All mating surfaces of housing, housing gasket and rear of engine block must be free of oil, fuel, water, gas-
ket adhesive and other contaminants during assembly.
1.
Install washer (25) and plug (26) in flywheel housing
21
22
(24). Torque plug to 40 lb-ft (54 Nm).
20
2.
Install plugs (18 and 19).
23
19
3.
Install plug (19) flush with surface of flywheel hous-
17
ing (24).
18
4.
Install two plugs (17).
5.
Install new gasket (20) and cover (21).
6.
Install three washers (23) and bolts (22).
24
25
26
394-633
7.
Install new gasket (14) and cover (15).
11
8.
Install washer (16) and bolt (10).
10
12
9.
Install washer (12) and bolt (11).
16
15
14
24
394-634
10.
Install lifting device to flywheel housing assembly (24).
11.
Use lifting device to position flywheel housing assembly (24) on end on flat surface.
0262 00-4
