TM 5-3805-248-23-2
LINKAGE ADJUSTMENT - CONTINUED
0283 00
ADJUSTMENT - CONTINUED
NOTE
Perform steps 2 through 4 only if inspection indicates detent is not in position 1 on manual shift cam.
1
2.
Install woodruff key (1), lever (2), bolt (5), washer (3)
2
and nut (4) on selector shaft.
3
3.
Manually move lever (2) until detent is in third notch
4
of manual shift cam marked 1.
5
DETENT
SELECTOR
SHAFT
CAM
4.
Inspect the position of spool A in hydraulic selector valve body. Forward edge of spool A must be flush with face of
hydraulic selector valve body. If spool A is not in correct position, perform steps 5 through 7. Otherwise proceed to step
8.
NOTE
Perform steps 5 through 7 only if inspection indicates spool A is not in correct position.
5.
Use a to wrench, loosen locknut A and turn spool A until its forward edge is flush with front face of hydraulic selector
valve body.
6.
Holding spool A to prevent it from turning, tighten locknut A to 25 lb-ft (34 Nm).
0283 00-2
