TM 5-3805-248-23-2
LINKAGE ADJUSTMENT - CONTINUED
0283 00
ADJUSTMENT - CONTINUED
8.
Inspect the position of spool B in hydraulic selector valve body. Forward edge of spool B must be flush with face of
hydraulic selector valve body. If spool B is not in correct position, perform steps 9 and 10.
NOTE
Perform steps 9 and 10 only if inspection indicates spool B is not in correct position.
9.
Using a wrench, loosen locknut B and turn spool B until its forward edge is flush with front face of hydraulic selector
valve body.
LOCKNUT B
SPOOL B
FORWARD
EDGE
HYDRAULIC
DETENT
SHIFT CAM
10.
Holding spool B to prevent it from turning, tighten locknut B to 15 lb-ft (20 Nm).
11.
Using locking pliers, rotate transmission selector shaft until detent is at position 1 (third notch) on hydraulic shift cam.
NOTE
Valve assemblies may need to be partially removed (WP 0280 00).
12.
Inspect the position of four spools C in selection valve body. Forward edge of each of four spools C must be flush with
front face of selection valve body. If four spools C are not in correct positions, perform steps 13 and 14.
0283 00-4
