TM 5-3805-248-23-2
CONTROL GROUP PRESSURE TEST - CONTINUED
0284 00
INSTALLATION
WARNING
Both axles must be removed and steering linkage must be disconnected before attempting this procedure.
Failure to follow this procedure may cause injury.
NOTE
If lever is not available for installation, locking pliers may be substituted.
1.
Install lever, spacer and bolt from throttle control kit
on governor linkage located on left side of engine.
SPACER
BOLT
Position lever so when it is pulled it will give maxi-
mum travel of governor linkage.
2.
Connect chain to lever and route as straight as possible
through open areas to rear of vehicle.
CHAIN
LEVER
394-820
3.
Remove two bolts (1) and washers (2) from transmission case.
4.
Install bracket and two bolts (1).
5.
Install handle through top of bracket.
6.
Adjust chain on yoke so length is just long enough to thread end of yoke on handle and install.
7.
Turn handle clockwise and observe if governor linkage is moving. If not, adjust length of chain.
0284 00-2