TM 5-3805-248-23-2
TRACTOR WHEEL AND TIRE MAINTENANCE - CONTINUED
0302 00
INSTALLATION
9
1.
Lightly coat axle housing with clean lubricating oil.
2.
Install new seal (10) on axle housing.
3.
Heat cone bearing (9) in lubricating oil at 275F
(135C) for 30 minutes and install in axle housing.
394-424
10
AXLE HOUSING
4.
Install cups (8) on tire and wheel assembly.
5.
Install ring (7) and new seal (6) on tire and wheel assembly.
6
8
7
WARNING
Use caution when handling heavy parts. Provide adequate support and use assistance during procedure.
Ensure that any lifting device used is in good condition and of suitable load capacity. Keep clear of heavy
parts supported only by lifting device. Failure to follow this warning may cause injury or death.
NOTE
Tire and wheel assembly weighs 2,200 lb (1,000
kg).
6.
Attach lifting device to tire and wheel assembly.
7.
Install tire and wheel assembly on axle housing.
8.
Install cone bearing (4) on tire and wheel assembly.
4
9.
Position link bracket on gear and internal gear (5)
assembly.
10.
Install gear and internal gear (5) assembly on tire and
wheel assembly.
5
394-421
11.
Remove link bracket.
0302 00-7
