TM 5-3805-248-23-2
STEERING FLOW METER TEE TEST PROCEDURES
THIS WORK PACKAGE COVERS
Preparation for Test, System Test, Comparison of Tests, Blocked Cylinder Test (All Cylinders Blocked), Comparison of
Tests, Blocked Cylinder Test (Right Side Cylinder Blocked), Comparison of Tests
INITIAL SETUP
References
Maintenance Level
Direct Support
WP 0019 00
Tools and Special Tools
WP 0020 00
Tool kit, general mechanic's (Item 113, WP 0338
Shop equipment, field maintenance (Item 104, WP
Tool outfit, hydraulic system test and repair
(HSTRU) (Item 114, WP 0338 00)
Equipment Condition
Personnel Required
Machine parked on level ground (TM 5-3805-248-
10)
Two
WARNING
Do NOT remove hydraulic tank filler cap or disconnect or remove any hydraulic system line or fitting
unless hydraulic system pressure has been relieved. Hydraulic system pressure can be over 2,500 psi
(17,237 kPa), even with engine and pump OFF. To relieve pressure, lower all hydraulic attachments to
the ground and shut down engine. Move control levers through all operating positions, then SLOWLY
loosen hydraulic tank filler cap. After maintenance, tighten all connections before applying pressure.
Escaping hydraulic fluid under pressure can penetrate the skin, causing serious injury or death.
At operating temperature, hydraulic oil is hot. Allow hydraulic oil to cool before disconnecting any
hydraulics. Failure to do so could result in injury.
CAUTION
Wipe area clean around all hydraulic connections to be opened during removal. Cap oil lines and plug open-
ings after removing lines. Contamination of hydraulic system could result in premature failure
