TM 5-3805-248-23-2
STEERING CYLINDER REPAIR - CONTINUED
0308 00
ASSEMBLY - CONTINUED
NOTE
Seals are label with "This side out," which should face the rod end.
6.
Use driver and hammer to install new seal (18), with
HEAD
lip toward outside of cylinder.
ASSEMBLY
7.
Install ring (14) and new preformed packing (13).
8.
Install seal guide on rod (2). Tapered end of seal guide
faces threaded end of rod.
9.
Install head assembly on rod (2).
2
10.
Remove seal guide from rod (2).
394-934
11.
Install new seal (11) and new rings (9 and 12) on pis-
9
ton (10).
10
11
12
394-933
12.
Install piston assembly on rod assembly (2).
8
13.
Use clean lubricating oil to lubricate threads of nut (8).
2
WARNING
Use care when installing nut. Nut is torque
to 1,600 lb-ft (2,170 Nm).
14.
Use torque multiplier to install nut (8) and torque to
PISTON
1,600 lb-ft (2,170 Nm).
ASSEMBLY
394-932
0308 00-6
