TM 5-3805-248-23-2
DRAFT FRAME ASSEMBLY SHOES MAINTENANCE - CONTINUED
0314 00
CLEANING AND INSPECTION
WARNING
Solvent cleaning compound MIL-PRF-680 Type III is an environmentally compliant and low toxic
material. However, it may be irritating to the eyes and skin. Use protective gloves and goggles. Use in
well-ventilated areas. Keep away from open flames and other sources of ignition.
Particles blown by compressed air are hazardous. DO NOT exceed 15 psi (103 kPa) nozzle pressure
when drying parts with compressed air. Use a maximum of 30 psi (207 kPa) when cleaning compo-
nents. DO NOT direct compressed air against human skin. Failure to follow this warning may result in
injury or death. Make sure air stream is directed away from user and other personnel in the area. To pre-
vent injury, user must wear protective goggles or face shield.
1.
Clean all parts with solvent cleaning compound and dry with compressed air.
2.
Inspect all parts for damage and replace as necessary.
INSTALLATION
Install shim pack, draft frame assembly shoe and three bolts on draft frame.
ADJUSTMENT
1.
Start engine (TM 5-3805-248-10).
2.
Lower bowl (TM 5-3805-248-10) until weight of bowl is off jack stands.
3.
Remove jack stands from rear of bowl.
4.
Raise bowl (TM 5-3805-248-10). Hold in RAISE position until bowl assembly wheels are on ground.
5.
Stop engine (TM 5-3805-248-10).
6.
Measure draft frame assembly shoe (2) and bowl wear plate on draft frame (4). Clearance must not be greater than 0.12
in. (3 mm). Measure clearance at top and bottom of draft frame assembly shoe. If clearance is larger than specified, start
engine (TM 5-3805-248-10) and repeat steps 1 through 5, adjusting shim pack until clearance is within specification.
END OF WORK PACKAGE
0314 00-3/-4 Blank
