TM 5-3805-248-23-2
ALTERNATOR (BOSCH) REPAIR - CONTINUED
0359 00
DISASSEMBLY - CONTINUED
8.
Remove two screws (14) and lockwashers (15).
NOTE
20
19
21
18
22
Testing of regulator is necessary prior to
removal. Refer to Testing, step 2.
9.
Separate regulator (16) from frame (9), exposing two
field coil wires (17) and diode assembly wire (22).
17
10.
Remove screw (20), lockwasher (18), screw (21) and
16
lockwasher (19), disconnecting two field coil wires
(17) and diode assembly wire (22) from regulator (16).
15
14
9
394-1360
NOTE
Testing of field coil wire is necessary prior to further disassembly of alternator. Refer to Testing, step 4.
11.
Remove four screws (31) and washer (32).
CAUTION
Use care not to damage stator with screwdrivers when prying from frames.
12.
Use two screwdrivers to separate frame (9) assembly from frame (7) assembly.
13.
Position frame (7) assembly in arbor press.
14.
Using arbor press, remove rotor (34) from frame (7) assembly.
15.
Remove spacer (33).
CAUTION
Epoxy putty covers field coil wires. Care must be taken when removing this epoxy so that wires are not
damaged.
16.
Separate field coil wires (17) and field coil (23) from frame (7).
17.
Remove six screws (26) and lockwashers (27).
18.
Remove all epoxy putty from groove in frame (7).
19.
Remove ring (24) and bearing (25).
20.
0359 00-2
