TM 5-3805-248-23-2
STARTING MOTOR (DELCO-REMY) REPAIR - CONTINUED
0361 00
DISASSEMBLY - CONTINUED
WARNING
Eye protection must be worn when performing maintenance where components or particles could fly
out during procedure. Failure to follow these instructions may cause injury.
Some components are under spring tension. Wear eye protection and use caution when disassembling to
avoid injury.
4.
Compress spring (8).
5.
Remove ring (6), retainer (7), spring (8), retainer (9),
boot (10) and washer (11) from shaft of plunger (1).
6
7
8
9
10
11
1
394-1373
6.
Remove nut (17) and connector (16).
7.
Remove nut (22) and washer (21).
NOTE
Tag all wire connectors, cables and wiring harnesses prior to disconnecting to ensure correct installation.
8.
Disconnect wire assembly (12).
9.
Remove two plugs (15) and seals (14) from housing (13). Discard two seals.
10.
Remove two screws (18) through plug (15) ports, disconnecting field coil (19) from plate (20) assembly.
11.
Use scribe to match-mark motor end frame housing (13) assembly.
17
16
15
14
13
12
18
19 (HIDDEN)
21
20 (HIDDEN)
22
14
15
394-1374
0361 00-2
