TM 5-3805-248-23-2
DIFFERENTIAL AND BEVEL GEAR REPAIR - CONTINUED
0376 00
DISASSEMBLY - CONTINUED
62.
Use bearing puller attachment to remove bearing (97)
from pinion gear (92).
63.
Remove slug (98) from pinion gear (92).
97
98
394-1496
92
64.
Remove tube assembly (100), connector (99), nut
99
100
(101) and fitting (102) from carrier (81).
101
102
81
394-1497
CLEANING AND INSPECTION
WARNING
Solvent cleaning compound MIL-PRF-680 Type III is an environmentally compliant and low toxic
material. However, it may be irritating to the eyes and skin. Use protective gloves and goggles. Use in
well-ventilated areas. Keep away from open flames and other sources of ignition.
Particles blown by compressed air are hazardous. DO NOT exceed 15 psi (103 kPa) nozzle pressure
when drying parts with compressed air. Use a maximum of 30 psi (207 kPa) when cleaning compo-
nents. DO NOT direct compressed air against human skin. Failure to follow this warning may result in
injury or death. Make sure air stream is directed away from user and other personnel in the area. To pre-
vent injury, user must wear protective goggles or face shield.
1.
Remove all preformed packing material from mounting surfaces.
2.
Clean all parts with solvent cleaning compound and dry with compressed air.
3.
Inspect all parts for damage and replace as necessary.
0376 00-14
