TM 5-3805-260-24TORQUE CONVERTER CLEARANCE CHECKSTORQUE CONVERTER CLEARANCECHECKSTools NeededAB5B9079Nut48S2328Dial Test Indicator Group11.There must be a minimum radial (running) clearance between the inside diameter of the rotating housing and turbine.2.Check the clearance between the inside diameter of the rotating housing and the turbine as follows:a) Install tooling (A) in four positions in the rotatinghousing as shown.b) Put the rotating housing on a smooth fiat surface.Install turbine (I) in the housing.c) Put tooling (B) in the position shown.d) Push turbine (I) toward tooling (B) until it makescontact with the inside diameter of the rotating housing.Adjust the dial indicator until it is on zero. Slide theturbine 180° away from tooling (B) until it makes contactwith the other side of the rotating housing. Make a recordof the dimension measured.e) Make this check at several locations around thehousing. Make a record of each of the dimensionsmeasured. The largest dimension measured is usedfor the clearance between the two parts. The totalclearance measured across the diameters must be.020 to .040 in. (0.51 to 1.02 mm) With a maximumpermissible clearance of .045 in. (1.14 mm). Theradial (running) clearance is half of the dimensionsmeasured.3-174
Integrated Publishing, Inc. - A (SDVOSB) Service Disabled Veteran Owned Small Business