TM 5-3805-260-24TORQUE CONVERTER24.Install two 5/16"-18 NC guide pins 6 in. (15.2 cm) long in the rotating housing. Put rotating housing (23) in position over the turbine. Install five of the twenty-four bolts to hold the housing in position. Tighten the five bolts to a torque of 20 + I lb.ft. (25 + I N.m).25.Install ring (24) in bearing (25). Install the bearing in the rotating housing as shown.26.Heat inner race (26) to a maximum temperature of275'F (I 35°C) and install it on the end of the shaft asshown.27.Install pin (29) in the end of the shaft. Install retainer(28) and bolt (27). Tighten the bolt to a torque of 81 +4 lb.ft. (11 I + 5 N.m).3-171
Integrated Publishing, Inc. - A (SDVOSB) Service Disabled Veteran Owned Small Business
