TM 5-3805-260-24
TORQUE CONVERTER
11.
Heat inner race (11) to a temperature of 275°F
(135°C). Install the race on the shaft as shown
until it makes contact with the shoulder on the
shaft.
12.
Install bearing (13) on the shaft. Heat inner race
(12) to a temperature of 275F (1 135°C) and
install it on the shaft. sure the race is pushed
down as far as possible.
13.
Temporarily install yoke (14) with two bolts and
washers.
14.
Turn the shaft around in the vise.
15.
Use tooling (C) to install sleeve (15) in the
carrier. Install the sleeve until it makes contact
with the counterbore in the carrier. Make sure
the tab on sleeve (15) fits in the groove of the
carrier.
3-168
