TM 5-3805-260-24
TORQUE CONVERTER
6.
Install the bearings and retainers in two gears
(5). Make sure the threaded hole in the retainer
is toward the bottom of gears when they are
installed.
7.
Put two gears (5) in position in the converter
housing as shown. Install bolts (6) that hold
them. Tighten the bolts to a torque of 36 + 2 Ib.
ft. (46 + 3 N-m).
8.
Install adapters (7) in both gears. Install rings (8)
that hold the adapters in position.
9.
Put shaft (10) in a vise as shown. Do not
damage the splines on the shaft.
10.
Install ring (9) with tool (D).
3-167
