TM 5-3805-260-24BOWL AND EJECTOR CONTROL VALVE12.Install sleeve (36) on valve spool (23). Install thevalve spool in the body.13.Install 0-ring seal (41) in cap (37). Put the sealson valve spool (38) and plug (40). Install valvespool (38), spring (39) and plug (40) in cap (37).NOTE: Put 4L7464 Silicone Grease on the ends of thevalve spools before the installation of the caps.14.Install cap (37) and two bolts (42). Install the sealin cap (44) and three balls (43) on the valvespool. Install cap (44) on the valve spool andinstall two bolts to hold it. Tighten the four boltsto a torque of 10 to 13 lb.ft. (14 to 18 N.m).NOTE: Put 4L7464 Silicone Grease on the ends of thevalve spools before the installation of the rubber seals.15.Install washers (45), retainers (47) and rubberseals (46) on the valve spools. Install the fourscrews that hold the retainers.end by:a) install bowl and ejector control valve3-355
Integrated Publishing, Inc. - A (SDVOSB) Service Disabled Veteran Owned Small Business
