TM 5-3805-260-24BOWL AND EJECTOR CONTROL VALVEDISASSEMBLE BOWL AND EJECTORCONTROL VALVETools NeededAB1P1857Snap Ring Pliers11P1856Snap Ring Pliers1start by:a) remove bowl and ejector control valve1.Remove four screws (1), retainers (3), rubberseals (2) and the washers from the valve spools.2.Remove four bolts (4). Remove caps (5) and (6)from the body. Remove cap (6) carefully becauseof the three balls on the valve spool.3.Remove the O-ring seal from the front of cap (5).Remove plug assembly (7), the spring and thering from cap (5).4.Remove sliding door cylinder valve spool (8) andbowl lift spool (9) from the body. Remove sleeve(10) from spool (8). Remove the two O-ring sealsfrom inside the body. Check the condition of theseals. If the seals have damage, use new parts forreplacement.5.Remove snap ring (12) with tool (A). Removethe washer, the spring and the plunger from in-side valve spool (8). Turn retainer (1 I) off valvespool (8). Remove the piston assembly, thespring and the two washers from the spool.3-350
Integrated Publishing, Inc. - A (SDVOSB) Service Disabled Veteran Owned Small Business
