TM 5-3805-260-24
BLOCKING LOCATION FOR EJECTOR CYLINDER
(Test 43)--
(See Tee Test Tooling Chart for parts reference)
BLOCKING LOCATION FOR RIGHT BOWL
CYLINDER
(Test 45 and 46)
(See Tee Test Tooling Chart for parts reference)
BLOCKING LOCATION FOR TESTS OF THE
ELEVATOR PUMP
(LARGE SECTION)
(Tests 22 through 30, Chart C2)
(See Tee Test Tooling Chart for parts reference)
WARNING: Lower all implements to
ground. Stop the engine. Move the control
levers
through
OPERATE
and
HOLD
positions to release any pressure oil in the
hydraulic lines. All pressure in the lines must be
released to prevent injury to personnel and damage to
equipment when the lines are loosened. To loosen the
lines with pressure oil in them can cause the implement
to move and pressure oil to be released. Open the filler
cap for the hydraulic tank to release any tank pressure.
Close the cap.
NOTE: Tests 34 through 40 are leakage rate tests for
circuits.
BLOCKING LOCATION FOR ELEVATOR
ELEVATOR CIRCUIT TESTS
(See Tee Test Tooling Chart for parts reference)
CHAIN TO PREVENT ELEVATOR FROM MOVING
BLOCKING LOCATION FOR RELIEF VALVE
(Test 56)
(See Tee Test Tooling Chart for parts reference)
BLOCKING LOCATION FOR SPEED
CONTROL VALVE
(Test 55)
(See Tee Test Tooling Chart for parts reference)
4-48
