TM 5-3805-260-24SCRAPER AXLESREMOVE SCRAPER AXLESTools NeededA9S8900Cylinder Group1FT959Adapter15F9888Adapter15F9892Pin1955431Sleeve Assembly19S5433Adapter16H4158Pin17B2499Ring15P3100Pump Group1start by:a)remove scraper wheel assemblies, bearings and seals1.Bend the tabs of the plate (lock) from bolts (1) that hold the axle in the frame.2.Loosen bolts (1) approximately .25 in. (6.4 mm). Do not remove these bolts.3.Install tooling (A) and pull axle (2) loose.4.Remove tooling (A), bolts (1), the plate (lock), plate and shims from inside the scraper frame.5.Remove the axle from inside the scraper frame.6.Remove the axle from the scraper frame. The weight of the axle is 50 lb. (23 kg).INSTALL SCRAPER AXLESTools NeededAFT959Adapter15F9889Plug15F9892Pin11.Put the axle (1) in position in the scraper frame.2.Install the plate and bolts that hold the axle in the3.Install tooling (A) on the end of axle (1).4.Hit the axle with a hammer until the bolts that hold the axle can not be tightened more at a torque of 200 to 220 lb. ft. (270 to 295 N-m).5.Remove the bolts and plate that hold the axle in.6.Add enough shims behind the plate that holds the axle to get a minimum distance from the end of the axle to the plate of .125 in. (3.18 mm).7.Install the shims. plate, plate (lock) and bolts to hold the axle. Tighten the bolts to a torque of 200 to 220 lb. ft. (270 to 295 N. m).end by:a)install scraper wheel assemblies, bearingsand seals4-71
Integrated Publishing, Inc. - A (SDVOSB) Service Disabled Veteran Owned Small Business