TM 5-3805-260-24
ELEVATOR HYDRAULIC PUMP,
STEERING AND SCRAPER HYDRAULIC PUMP
3. Connect tube assembly (5) and hose assembly
(4) to the hydraulic pump.
4.
Connect hose assembly (6) to hydraulic
pump (l).
5. Fill the hydraulic system and transmission with
oil to the correct levels.
end by:
a)
install crankcase guard*
REMOVE AND INSTALL STEERING
AND SCRAPER HYDRAULIC
PUMP
start by:
a)
remove crankcase guard*
1. Drain the oil from the hydraulic system and torque
converter housing.
2. Disconnect tube assembly (5) and hose assemblies
(1) and (2) from hydraulic pump (3).
3. Remove the two bolts (4) and washers that hold
hydraulic pump (3) in position. Lower the hy-
draulic pump from the torque converter. The
weight of the hydraulic pump is 45 lb. (20 kg).
NOTE: Put oil in the hydraulic pump before installation.
4. Make sure the O-ring seal is in position and lift
hydraulic pump (3) into position in the torque
converter housing. Install bolts (4) and the
washers to hold the hydraulic pump.
5. Connect hose assemblies (I) and (2) and tube
assembly (5) to the hydraulic pump.
6. Fill the hydraulic system and transmission with oil to
the correct level.
end by:
a) install crankcase guard*
*This operation is in ENGINE DISASSEMBLY AND
ASSEMBLY section.
4-96
