TM5-3805-260-24
ELEVATOR HYDRAULIC PUMP
REMOVE ELEVATOR HYDRAULIC
PUMP
start by:
a)
remove crankcase guard*
*This operation is in ENGINE DISASSEMBLY AND
ASSEMBLY section.
1.
Drain the oil from the hydraulic system
and torque converter housing.
2.
Disconnect hose assembly (I) from the
rear of hydraulic pump (2).
3.
Disconnect tube assembly (4) and hose
assembly (3) from hydraulic pump (2).
4.
Disconnect
tube
assembly
(6)
and
remove housing (5) from hydraulic pump (2).
5.
Remove the two bolts that hold hydraulic
pump (2) to the left rear of torque converter
housing. Lower the hydraulic pump from
the machine.
INSTALL ELEVATOR HYDRAULIC
PUMP
NOTE: Put oil in the hydraulic pump before installation
1.
Make sure the O-ring seal is in position
and lift hydraulic pump (I) into position in the
torque converter housing. Install the bolts
and washers to hold the hydraulic pump.
2.
Put the O-ring seal and housing (3) in
position on the hydraulic pump and connect
tube assembly (2).
4-95
