TM 5-3805-260-24
Disassembly and Assembly
Wheel Bearings
2.
Put tape around the threads of the steering
knuckle to give protection to the threads when
the steering wheel is installed.
3.
Put (pack) GAA Multipurpose Grease in the
inner and outer bearing cones.
4.
Install inner bearing cone and seal (1) on the
steering knuckle.
5. Use two persons and install steer wheel
(2) on the steering knuckle.
Disassembly and Assembly
6.
Remove the tape from the threads on steering
knuckle.
7.
Install outer bearing (3) on the steering knuckle.
8.
Install washer (4) and locking washer (5) on the
steering knuckle.
9.
Install the nut on the end of the knuckle. Use tool
(B) to tighten the nut slowly to 70 Nm (50 Ib.ft.)
while the wheel is turned. Loosen the nut
completely. Tighten it again to a torque of 50 5
N.m (37 4 Ib.ft.). Bend one of the tines (tab) of
locking washer (5) into one of the notches in the
nut.
10.
Put the gasket and cover (6) in position on the
hub and install bolts (7) that hold the cover in
place.
5-22
