TM 5-3805-260-24
DIFFERENTIAL AND CARRIER ASSEMBLY (LOCK TYPE)
14. Lower the temperature of the large bearing cup
and small bearing cup (17). Install the bearing
cups in housing (18).
15. Heat larger bearing cone (20) in oil to a
maximum temperature of 275°F (I 35°C). Install
hearing cone (20) on pinion shaft (19) as shown.
16 Put pinion shaft in housing (18). Heat small
bearing cone (2 I) in oil to a maximum tempera-
lure of 275°F (135°C). Install bearing cone (21)
on pinion shaft (19).
17. Install nut (23). the lock and nut (22) on pinion
shaft ( 19). Tighten the nuts until a torque of 6 to
10 lb. in. (0.7 to 1.1 Nm) is needed to turn pinion
shaft (19).
18 Install spring pin (24) in carrier assembly (25).
19. Fasten a hoist to carrier assembly (25) and put it
in position on tooling (A) as shown.
3-240