TM 5-3805-260-24
EJECTOR CARRIER ROLLER
INSTALL EJECTOR CARRIER ROLLER
Tools Needed
A
1P510
Driver Group
1
1.
Install the bushing with tooling (A) and a press in
roller (I).
2.
Install pin (3), key (2) and washer (4) on the shaft.
3.
Install shaft (5) in the bracket. Slide roller (1) on the
shaft and install washer (6) and the bolt.
4.
Install bolt and nut (7) in the bracket. Lower the
ejector and adjust the roller until the clearance
between the ejector and scraper floor is .03 to .25 in.
(0.8 to 6.4 mm).
5.
Remove the hoist from the ejector.
4-164