TM 5-2350-377-13&P
0032
INSTALLATION
WARNING
Cleaning solvent is combustible. Wear protective goggles and gloves; use only in a well-
ventilated area; avoid contact with skin, eyes, and clothes; and do not breathe vapors.
Keep away from heat or flame. Never smoke when using cleaning solvent; the flashpoint
is 144F (62C). Failure to follow this warning may result in injury or death to personnel.
A fire extinguisher will be kept nearby when the solvent is used.
If personnel become dizzy while using cleaning solvent, immediately get fresh air and
medical help. If solvent contacts skin or clothes, flush with cold water. If solvent contacts
eyes, immediately flush them with water and get immediate medical attention.
When cleaning solvent is used, notify the local medical authority (preventive medicine)
and environmental coordinator concerning medical surveillance, respiratory protection,
and disposal requirements.
1.
Clean rubber round section groove (Figure 3, Item 5) in holder (Figure 3, Item 6) with solvent and rag.
2.
Put front lip (Figure 3, Item 8) of lens (Figure 3, Item 9) in inside groove of new seal (Figure 3, Item 3).
3.
Put lens (Figure 3, Item 9) with seal (Figure 3, Item 3) in lens and filter holder (Figure 3, Item 4). Make sure
lens (Figure 3, Item 9) and seal (Figure 3, Item 3) are seated firmly in holder (Figure 3, Item 4).
NOTE
Put filter on lens so wide ends of markings face up when holder is installed on body.
4.
Lay painted side of filter (Figure 3, Item 7) on top of lens (Figure 3, Item 8).
5.
Put plate (Figure 3, Item 2) on top of filter (Figure 3, Item 7). Install three screws (Figure 3, Item 1) in plate
(Figure 3, Item 2) and holder (Figure 3, Item 4).
1
2
3
9
8
7
4
5
6
M0011HBF
Figure 3.
Headlight Light Filter Installation.
03/15/2011Rel(1.8)root(maintwp)wpno(M00005)