TM 5-2350-377-13&P
0036
DISASSEMBLY
NOTE
If complete disassembly of the apron and dozer assembly is necessary, follow Steps (1)
through (6).
For disassembly of the apron and dozer assembly, follow Steps (7) through (13).
1.
Disassemble headlight assembly (WP 0030).
2.
Disassemble cutting edges:
WARNING
Do not work under vehicle unless hull is blocked and apron lockpins are installed. Failure
to comply may result in severe injury or death to personnel.
a.
Loosen two hex nuts (Figure 6, Item 10) on screws (Figure 6, Item 1) at dozer cutting edge
(Figure 6, Item 4).
b.
Remove sixteen nuts (Figure 6, Item 13), washers (Figure 6, Item 2), and screws (Figure 6, Item 3) from
dozer cutting edge (Figure 6, Item 4) and dozer blade (Figure 6, Item 5).
c.
Loosen four hex nuts (Figure 6, Item 8) on screws (Figure 6, Item 11) at dozer extension end bit
(Figure 6, Item 9).
d.
Unfold dozer blade (Figure 6, Item 5).
e.
Remove two hex nuts (Figure 6, Item 10), washers (Figure 6, Item 12), screws (Figure 6, Item 1), and
dozer cutting edge (Figure 6, Item 4) from dozer blade (Figure 6, Item 5).
f.
Remove four hex nuts (Figure 6, Item 8), washers (Figure 6, Item 7), screws (Figure 6, Item 11), and
dozer extension end bit (Figure 6, Item 9) from dozer extension (Figure 6, Item 6).
0036-6
03/15/2011Rel(1.8)root(maintwp)wpno(M00009)