TM 5-2350-377-13&P
0041
REMOVAL (LEFT SIDE)
WARNING
High pressure is present in the M9 ACE hydraulic system. Do not disconnect any hydraulic
system component unless hydraulic system pressure has been relieved. Ensure each of the
hydraulic control levers is moved several times through all positions, and the hydraulic tank
dipstick is slowly loosened to relieve pressure. Failure to comply may result in severe injury
to personnel.
CAUTION
Cap or plug all ports and ends of hoses and tubes to prevent contamination of hydraulic oil.
Failure to comply may result in damage to equipment.
NOTE
Removal procedures for right side of manifold, reference TM 5-2350-262-20, Hydraulic
Intermediate Manifolds and Fittings Replacement, Removal (Right Side). Procedures
below are for left side only.
Use two wrenches when disconnecting hydraulic lines from fittings.
Tag all hoses and tubes prior to removal, for installation.
1.
Disconnect five valve bank hoses (Figure 1, Item 14) from adapters (Figure 1, Item 13).
2.
Disconnect two HBF-TT track adjusting hoses (Figure 1, Item 5) from tee (Figure 1, Item 3) and elbow
(Figure 1, Item 7).
3.
Disconnect two valve bank hoses (Figure 1, Item 4) from tee (Figure 1, Item 3) and tee (Figure 1, Item 6).
4.
Remove reducer (Figure 1, Item 8) from tee (Figure 1, Item 6).
5.
Remove tee (Figure 1, Item 3) and tee (Figure 1, Item 6) from adapters (Figure 1, Item 9).
6.
Disconnect five tubes (Figure 1, Item 11) from four adapters (Figure 1, Item 12) and elbow (Figure 1, Item 10)
at front of manifold (Figure 1, Item 2).
7.
From hull access opening, disconnect four tubes (Figure 1, Item 1) from tee (Figure 1, Item 17), and fitting
(Figure 1, Item 18) at rear of manifold (Figure 1, Item 2). Disconnect hose (Figure 1, Item 16) from adapter
(Figure 1, Item 15).
0041-2
03/15/2011Rel(1.8)root(maintwp)wpno(M00013)
