TM 5-3800-205-23-1
TRANSMISSION SHIFT CONTROL CABLE REPLACEMENT - CONTINUED
0069 00
INSTALLATION - CONTINUED
10.
Install new tiedown straps to secure wiring harness
(23) to shift control cable (16).
11.
Install shift control cable (16) to machine with two
clamps (26), washers (25), and screws (24).
16
23
24,25
26
12.
Position washer (14) and nut (15) to shift control cable
11,12,13
(16).
14,15
8
13.
Push end of shift control cable (16) in through hole in
linkage housing (8).
14.
Inside linkage housing (8), install new seal washer
(13), washer (12), and nut (11).
16
15.
Tighten nuts (11 and 15) against linkage housing (8).
16.
Install nut (17) and bearing (18) to end of shift control
cable (16). Install grease fitting (19) to bearing.
17.
Connect bearing (18) to cam (20) with washer (22)
17
and screw (21). Lubricate bearing with grease.
18.
In cab, move transmission shift lever (TM 5-3800-
21,22
18
205-10-1 or TM 5-3800-205-10-2) to ensure full range
19
of movement. Adjust shift control cable (16), as
required, by positioning nuts (11 and 15). Tighten
nuts.
20
0069 00-8