TM 5-3800-205-23-1
TRANSMISSION SHIFT CONTROL CAM AND LINKAGE REPLACEMENT - CONTINUED
0070 00
REMOVAL - CONTINUED
7.
Remove two bolts (25), washers (26), and lube fitting
22
25,26
27
23,24
bracket (27) from cover (23). Set bracket aside.
NOTE
Three cable clamps and wiring harness are
also removed as cover is removed.
8.
Remove 16 additional bolts (22), cover (23), and gas-
ket (24) from top of control valve housing. Discard
gasket.
NOTE
Perform steps 9 through 12 to remove each of two rods.
Note position of rod and locknut at each spool to aid in installation.
9.
While holding spool (29) from rotating, loosen lock-
28
1
29
18
nut (28).
10.
Rotate spool (29) to separate spool from rod (18).
11.
Remove rod (18) from linkage housing (1).
12.
Remove locknut (28) from rod (18). Discard locknut.
0070 00-3
