TM 5-3800-205-23-1
TRANSMISSION HYDRAULIC CONTROL VALVE REPLACEMENT - CONTINUED
0148 00
INSTALLATION
NOTE
Coat new O-rings with clean oil before installation.
1.
Install two new O-rings (8) on each sleeve (7) and install sleeves in transmission case (4).
2.
Install two links in two bolt holes in control valve (3), to provide a balanced lift.
WARNING
Use extreme caution when handling heavy parts. Provide adequate support and use assistance during proce-
dure. Ensure that any lifting device used is in good condition and of suitable lift capacity. Keep clear of
heavy parts supported only by lifting device. Failure to follow this warning may result in death or injury to
personnel.
NOTE
Control valve weighs 70 lb (32 kg).
3.
Attach a nylon sling to links and attach a sling to a suitable lifting device. Take up slack in sling.
4.
Lift control valve (3) and position in transmission case (4).
5.
Install four washers (2) and bolts (1). Remove lifting device, sling, and links from control valve (3). Tighten bolts to 35
lb-ft (48 Nm).
6.
Move two sleeves (7) into control valve (3). Install washer (6) and bolt (5) to secure sleeves.
7.
Install transmission shift control cam and linkage (WP 0070 00).
END OF WORK PACKAGE
0148 00-3
