TM 5-3800-205-23-2
HYDRAULIC LINES AND FITTINGS REPLACEMENT - CONTINUED
0020 00
HYDRAULIC TUBE INSTALLATION
CAUTION
Use two wrench method when connecting non-quick disconnect connections to prevent damage to fittings.
NOTE
Hydraulic system uses several different style clamps. A four-bolt clamp is shown.
Lubricate new O-rings with clean oil before installation.
1.
Position tube (11) on machine.
2.
Remove protective caps from hose (10) and tube (11). Install new O-ring (12) to connect hose to tube.
3.
Install front half of clamp (14) with four bolts (13).
4.
Repeat steps 2 and 3 to install other end of tube (11).
10 11,12
390-1495
13
14
5.
Fill hydraulic tank (TM 5-3800-205-23-1, WP 0009 00 and WP 0010 00).
WARNING
If machine is parked indoors, DO NOT run engine unless exhaust fumes are vented to the outside. Failure to
follow this warning may cause injury or death due to carbon monoxide poisoning.
6.
Start engine (TM 5-3800-205-10-1) and check hydraulic lines for leaks.
END OF WORK PACKAGE
0020 00-6
