TM 5-3800-205-23-2
REAR WHEEL BEARINGS AND SEAL REPLACEMENT - CONTINUED
0029 00
REMOVAL - CONTINUED
3.
Using crossbar, remove roller bearing cone (5) from axle shaft (6).
4.
Remove plate (7) from axle shaft (6).
6
5
7
6
5.
Using driver and press, remove lip seal (8) from plate
(7). Discard lip seal.
INSTALLATION
NOTE
Spring side of lip seal must be toward
inside of plate.
1.
Using driver and press, install new lip seal (8) on plate
8
(7) until lip seal is even with outside surface of plate.
7
2.
Install plate (7) on axle shaft (6).
WARNING
Hot oil and components can cause injury to personnel. Do not allow hot oil or components to contact skin.
3.
Heat roller bearing cone (5) to 275F (135C) and install roller bearing cone on axle shaft (6).
0029 00-2
