TM 5-3805-248-23-1
ENGINE OIL AND OIL FILTER ELEMENT REPLACEMENT - CONTINUED
0022 00
REMOVAL - CONTINUED
2.
Remove oil filter element (2) from front, right side of engine compartment. Discard oil filter element.
394-003
3 (HIDDEN)
2
INSTALLATION
1.
Apply a light coat of clean lubricating oil to gasket of new filter (2).
2.
Install new oil filter element (2). Tighten by hand an additional 3/4 turn after gasket (3) comes in contact with base.
3.
Refill engine oil to "L" mark on the low idle side of gage. Refer to PMCS Introduction (WP 0019 00) for proper grade
of oil for expected temperature range.
4.
Start engine and run at low idle (TM 5-3805-248-10).
5.
Recheck oil level and ensure level is in crosshatched area between the "L" and "F" marks on low idle side of gage.
6.
Stop engine (TM 5-3805-248-10).
7.
Check for leaks around filter and oil drain valve areas.
8.
END OF WORK PACKAGE
0022 00-2